AUTOMATED FINISHING 2H-36


        




Automated Finishing,No.2H-36 Slurry Deburring Machine

Item Details
Bookmark This!
ManufacturerAUTOMATED FINISHING
Model Number2H-36
Condition:Used
Year:1991
Specific Location:111 Schelter Road
Lincolnshire, Illinois 60069
United States
Price:Contact Seller
Seller Stock Number23713
Device Details
Control Type:Texas Instruments Series 305-O5B Voltage (Machine):460 volt, 3 phase, 60 cycle
Digital Tachometer :Yes Spindle Counters:Yes
Rotating Tub:Yes
Additional Information
Automated Finishing,No.2H-36, 2-Spdl, Rotating Tub,Slurry Deburring Machine

Serial No. 2322 New - 1991

SPECIFICATIONS:
Floor Area Requirements 6'6" L x 4'6" W x 5' H
Work Tray 40" H

GENERAL INFORMATION:
The Model 2H-36 Spindle Type Finishing Machine is composed of the following

major components: (1) The Rotating Tube that carries the finishing media; (2)

The Two Spindle Supporting Heads; (3) The Two Spindle Assemblies; (4) The

Structural Base; and (5) The Electrical Controls.

The rotating tub measures 36" wide in diameter by 18-1/2" in depth and is

fabricated of 3/16" steel plate of all welded construction with the tub bottom

further reinfored with structural channels. A 3" wide section of the tub at

the bottom periphery is perforated and covered on the O.D. with fine mesh

screen to allow continual drainage of liquids from the tubs interior.

The tub is mounted on the vertical output shaft of a heavy duty gear reducer

driven by a 15 HP variable speed drive unit for 460 volt, 3 phase, 60 cycle

operation with a tub speed of up to 1200 SFM (Surface Feet Per Minute).

The spindle support heads are fabricated of heavy section structural steel

members and are rigidly gusseted to provide an integral rigid unit capable of

maintaining positive alignment of the spindle with respect to the rotating

tub. Raising and lowering of spindles is accomplished with an air cylinder.

Spindles are adjustable through a 20 degree range fore and aft of the flow of

material in the rotating tub and from 0 degrees to 20 degrees from

perpendicular to the outer periphery of the tub together with 3-1/2"

horizontal extension.

EQUIPPED WITH:
Texas Instruments Series 305-O5B Programmable Controller
ATC Spindle Counters (2) Each Forward & Reverse
Control for Variable Tub Speed with Digital Tachometer

Contact Info
Fine out more about this seller:

 

Contact Individual Listing Companies Directly for Information and Pricing Related to Their Items or Service.
© GotMachinery Inc. 2010, All Rights Reserved